How do you adjust the throttle on a stihl weedeater

Start the trimmer and hold the throttle trigger in all the way to get the trimmer head spinning at maximum speed. Turn the H screw clockwise with a carburetor adjustment tool until the head is spinning as fast as it will go, then back off the screw carefully until the RPMs start to decrease.

How do you adjust the high and low on a Stihl weedeater?

Start the trimmer and hold the throttle trigger in all the way to get the trimmer head spinning at maximum speed. Turn the H screw clockwise with a carburetor adjustment tool until the head is spinning as fast as it will go, then back off the screw carefully until the RPMs start to decrease.

Why does my Stihl trimmer bog down?

The trimmer can sputter and stall if it isn’t getting enough fuel, and that can happen simply because the fuel filter is dirty. Fuel filters are inexpensive, and it’s more practical to replace a dirty one than it is to try to clean it. … While you’re cleaning the filter, try running the trimmer with the cap loosened.

How do you adjust the idle speed on a Stihl weedeater?

Place the Weed Eater trimmer on a workbench or other flat surface. …
Locate the idle speed adjustment screw situated to the side and slightly behind the air filter. …
Turn the adjustment screw to the right, or clockwise, to increase the engine idle speed.

How do you adjust the idle on a Stihl hedge trimmer?

Turn the low speed screw (L) slowly counter clockwise until the engine runs and accelerates smoothly. It is usually necessary to change the setting of the idle speed screw (LA) after every correction to the low speed screw (L).

Why does my trimmer dies when I give it gas?

Why does my weed eater die when giving it gas? The most common causes of a weed eater dying when throttled are fuel issues, insufficient air intake, or problems with the exhaust. You should follow the path that the fuel travels to identify the issue.

What is the LA screw on a Stihl chainsaw?

The LA setting on Stihl chainsaws is controlled by a screw on the outer housing of the engine that adjusts the flow of fuel and air through the carburetor. This screw is inside the engine housing on the carburetor, but is accessible through a hole or gap in the outer housing of the saw.

Why does my strimmer cuts out when revved?

If your trimmer engine idles, but stalls on throttle, check the following parts: the gasket, primer bulb, fuel filter, air filter, fuel vent, fuel line, and carburetor. … Remove the air cleaner cap and filter, checking for any obstructions in the way that could block air flow, starving the engine of oxygen.

Where is fuel filter on Stihl weedeater?

The gas filter is inside the fuel tank on the end of the incoming fuel line. When your Stihl becomes difficult to start or often stalls even with a full tank of fuel, chances are the fuel filter is dirty.

How do you adjust a Stihl FS 76 carburetor?

Step 1: Remove the String Spool.
Step 2: Clean or Replace the Air Filter.
Step 3: Remove the Screw Guards.
Step 4: Adjust the High-Speed Screw.
Step 5: Adjust the LA Screw.
Step 6: Adjust the L Screw.
Step 7: Set the Final Idle Speed.

Article first time published on

How do you adjust a Zama carburetor?

Locate the carburetor on the side of the engine, directly under the air filter. On the side of the carburetor are three adjustment screws; there are stamped letters beside these screws, “L” for the low speed adjustment screw, “H” for high-speed adjustment and “TAS” for the idle adjustment.

How does Stihl 4 mix engine work?

Like the four-stroke and two-stroke engines, the STIHL 4-MIX™ engine is an internal combustion engine. Energy is released during combustion of the fuel-air mixture in the cylinder, which is converted into motion via the piston and crankshaft. The carburetor supplies the correct mixture of air and fuel.

Is a Stihl trimmer A 4-stroke?

So, for whatever it’s worth, you’ll have to stop less often for refueling, but you’re not getting the best fuel economy with this model. It also bears mentioning that, while the Stihl FS 91 R does feature a 4-stroke engine, it still requires premix fuel.

Why does my Stihl hedge trimmer keep cutting out?

The carburetor might be clogged. A clogged carburetor is most commonly caused by leaving fuel in the hedge trimmer for a long period of time. … This sticky fuel can clog up the carburetor and cause the engine to stall or run roughly. If the carburetor is clogged, try cleaning it with carburetor cleaner.

How do you adjust a carburetor on a Stihl pole saw?

To do this, turn the “L” screw clockwise as far as it will go, using a flat-head screwdriver, then turn it counterclockwise as far as it will go. If it turns more than one complete revolution, it’s a type A carburetor, and if it turns less than one revolution, it’s a type B carburetor.

How do you adjust the idle on a Stihl ms250?

Adjust the low-speed and idle screws if the chain turns on its own when idling. Turn the low-speed screw clockwise until it stops, and then one turn counterclockwise. Turn the idle speed screw counterclockwise until the chain stops turning on its own, and then turn the screw one-fourth turn clockwise.

What does HL and La mean on a Stihl chainsaw?

One marked “H”, for high speed, one marked “L”, for low speed and one marked “LA”, which is your low speed air adjustment for idle.

What does L and H mean on a carburetor?

They are typically labeled L (low speed jet), H (high speed jet), and I (idler jet).

Why does my 2 cycle engine stall when I give it gas?

One of the possible reasons why your two stroke engine is stalling when revved is because of a clogged filter. … The fuel filter stops any debris or gunk that may be in the fuel tank from entering the carburetor and engine. If this filter gets clogged, then not enough fuel can be accessed by the engine for it to run.

Why does my Weedeater only run on half choke?

A weed eater only runs on half choke when there is dirt or a clog in the carburetor or gas cap that needs to be cleaned. A dirty carburetor will restrict fuel and airflow. When the check valve in the gas cap is clogged, the fuel creates a vacuum and gets vapor locked. The choke allows air inside.

Why does my 2 stroke keep cutting out?

There is usually a special one-way valve in the fuel tank cap that allows the air to come in to the top of the fuel. … The obvious effect this has on the engine is less fuel getting into the carburettor, which can contribute to the engine bogging down and eventually it will cause the engine to stop completely.

Why is my strimmer smoking?

Smoking can be caused by an overly rich fuel mixture or the presence of oil in the combustion chamber. On the more serious side, your engine may be seizing because it doesn’t have enough oil.