Resetting a Hunter X-Core is easy. To reset the irrigation controller, all you need to do is press the negative, the hand and the program keys at the same time, then use a small tool to press in the small reset button on the side of your controller. A small screwdriver or a pen will do the trick.
How do I reset my Hunter SRC sprinkler system?
- Unplug the controller’s transformer and remove the battery.
- Press and hold down the , and buttons.
- Plug the controller’s transformer back in.
- Release the , and buttons. The display should now show 12:00a. m.
- All the memory has been cleared and the controller may now be reprogrammed. Reinstall the battery.
How do you adjust Hunter rotating sprinklers?
Insert the plastic key end of the Hunter wrench into the adjustment socket . While holding the nozzle turret at the right stop, turn the wrench clockwise. Each full 360° turn of the wrench will increase the arc 90°. Adjust to any arc between 40° and 360°.
How do I reset my hunter X2 sprinkler?
- Turn the dial to the RUN position. …
- Press and hold the program button.
- Press and release the RESET button located inside the lower wiring compartment. …
- When the display reads the controller station count; (e.g. 14) then DONE, release the PRG button.
How do I manually test my orbit sprinkler system?
Turn the dial to the “Auto” position and move the slide switch for the desired valve up to the “Manual On” position to test valves on Orbit’s “Individual Station Slide” timers. To test all the valves in sequence, simply press the “Manual” key and press “Enter.”
Why is my hunter sprinkler head not rotating?
The most common reason for a sprinkler to stop rotating is the accumulation of debris in the filter. … When in operation, water turns a small turbine in the base of the sprinkler, which drives a series of gears that cause the head to rotate. The Hunter gear drive mechanism is sealed from dirt and debris.
How do I switch programs in Hunter Pro C?
- Start with the dial in the RUN position.
- Press and hold the button. Turn the dial to the WATER DAYS position.
- Release the button.
- Use the and button to change program modes.
What is RS on sprinkler controller?
The function of RS terminal was to notify the controller the status of the rain sensor. Rachio uses a different approach, Commons are dedicated to valves and rain sensor can be connected to the dedicated inputs.What is Hunter SRC Plus?
9. The Hunter SRC Plus is remote-ready for use with the SRR or ICR remote control system. The remote makes it possible for contractors and end-users alike to operate an system without having to walk back and forth to the controller.
How do you use Hunter WIFI?Any member of the Hunter College community (students, faculty, and staff) can use Hunter’s wireless network. Simply have your wireless device connect to the network called “hunternet”, and then open a web browser. The browser will go directly to an authentication page where you type in your Hunter NetID and password.
Article first time published on
